Denali Smart Controller Ktm 1050 Adv

Leverage the flexibility and intelligence of the CAN bus electrical system to drastically simplify the installation of accessories on your vehicle. The CANsmart provides plug-n-play installation and integrated control of up to four accessories that can be controlled directly from the existing KTM handlebar switches. Unlike the first-generation CANsmart, this new accessory can provide 10 Amps of continuous power, and you can modulate auxiliary lights for greater visibility and set the left and right side lights to turn off independently when you activate the corresponding turn signal.

Installation instructions available in the 'Attached Documents' section.

Main features of the Denali CANsmart:

- Set auxiliary lights to switch from a programmable high/low setting with the factory high beam switch.

- Independently control two sets of lights ON/OFF and adjust the intensity level directly from the vehicle's original switches.

- Adjust the brightness of auxiliary lights as needed.

- Control the brightness of auxiliary lights when turning, reducing the brightness of auxiliary lights when the turn signal is activated to make it clearly visible.

- Plug & Play horn installation - Quickly and easily connect aftermarket horns without needing to add additional wiring or a relay.

- Switched power, meaning any accessory connected to this circuit will turn on and off with the motorcycle's ignition.

- Delayed timeout: allows powering accessories even after the vehicle is turned off, for up to 30 seconds.

SKU	DNLWHS13000
ID	64443