Description
Specific rear rack for MONOKEY® or MONOLOCK® top-case to be combined with the MONOKEY® M5, M7 plates, or with the MONOLOCK® M5M or M6M plates, or with the aluminium bag holder EX2M / maximum load allowed 6 Kg / it is not compatible with the original side-case holder.
Additional Info
| Product Code | GIVI-1121FZ |
|---|---|
| ID | 5555 |
Reviews
- strongReview by tomy nguyen
-
very strong mount. used to mount givi outback 58l box. my wife can use it as a backrest and not break off. im sure it can hold a lot of weight. welds are good and seem very quality. nice finsh no rust (Posted on 04/06/2016)Overall
- Simple and strong top case rackReview by sean salimian
-
This top case rack is attached where the handles used to be near the rear of the seat, this is a very solid mount it feels like it can hold a lot of weight. Comes with all the hardware you need and some other small trim pieces. You must buy a mounting plate if you are using a monolock or monokey setup with givi. I feel like this is a little expensive for two pieces of metal but it does what it is supposed to and I'm happy with it. You can also attach the rack for side cases to these rails along the sides where it has female threads available. Not much else to say about this it's a piece of metal with the right bends and holes placed on it to do what it needs to do (Posted on 09/08/2016)Overall
- Great RailsReview by Matthew Strickland
-
Nice set of rails for a top case and for the GIVI PL1121CAM racks for the Trekker Outback cases. Fit and finish is excellent and was easy enough to install. As with all assemblies like this, it's helpful to leave the bolts a bit loose at first and then tighten once everything is in place to square everything up easiest. Also be careful removing the stock grab rail bolts on a '14 CB500x because they seem to have been installed torque to yield. (Posted on 12/04/2017)Overall
- Essential support bracketReview by Jason Deadmond
-
These are fairly easy to install with the 1121CAM side case racks. Just requires removing the seat and switching out a connect and getting rid of the passenger handles. However, it does not include a m5 or m5m plate to connect the pieces for the top case. (Posted on 14/05/2018)Overall
- Update, made of weak metal, no replacement from Motostorm.itReview by Sean Salimian
-
I had it loaded with 3kg of clothes/books on the back of my bike and hit a dip in the road and the bars bend down cracking my tail light. This website refused to replace it stating that i probably had it over loaded. (capacity is 6kg) not happy with my product or customer service from Motostorm (Posted on 16/09/2018)Overall
- Perfect fitReview by Jens Jakob Andersen
-
This is the perfect fit for the CB500X - and supplements the side pannier racks quite nicely. In addition to the fit, it is also very easy to install - and the installation instructions are easy to read and follow - even for a beginner. (Posted on 29/12/2022)Overall
Write Your Own Review
Info
Bikes
You may also be interested in the following product(s)
